4/26/2023 0 Comments Reloading 7.62 x25 tokarevI am GUESSING what is going on is the case neck tension is all at the very mouth of the house, not through the entire neck. If the bullet is seated a hair further, the bullet falls in to the case. If the bullet seats down sufficiently to reach the crimp groove, the bullet falls until it hits the other side of the crimp groove. If I put enough taper crimp on it to actually hold the bullet in place moderately, I am bulging the case neck badly.įor the Hornady bullets this is compounded because they have a crimp grove. No matter how little or how much I am expanding the case neck, I seat a bullet and then no matter a taper crimp or no crimp I can push the bullet right in to the case. Yes I've tried the resizing die at various positions and just can't get it perfect, but it is close enough I don't have any real concerns (it isn't tight enough that it should effect chambering or extracting). New PPU brass drops in and falls out (not resized at all though) as do S&B and PPU commercial loads. Once fired PPU brass once resized will drop in the chamber, but it takes a bit of a tap to get it seated fully and need a finger nail to pull it back out. ![]() ![]() The cases aren't quite resizing correctly, though they are "good enough". ![]() I have Lee Pacesetter dies and I cannot get it to work. So I am trying to reload Tokarev for the first time.
0 Comments
|
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |